Author: kelley

Table of Contents Section 5: Electrodes 5.1 Electrode Handling Precautions 5.2 Shafts 5.3 RDE Tips 5.4 Single-Piece RDE Designs 5.5 RRDE Tips 5.6 RCE Tips

In the event that the rotator system is not going to be used for a long period of time, it should be stored in the original packaging material to prevent damage. It should be stored at temperatures between and , and at humidity levels less than non-condensing. Retain the original packing materials for future use.…

This section describes some basic troubleshooting considerations when working with a rotator. Each of the basic problems is represented in a toggle below with suggested cause or action that should be taken. If problems with the rotator persist, contact the factory for further assistance (see Section 1.5).

Table of Contents Section 3 – Installation 3.1 Site Preparation 3.2 Unpacking and Setting Up the Rotator 3.1 Site Preparation The rotator system should be located on a sturdy table or laboratory bench with ample clearance around the perimeter of the rotator enclosure. The front of the rotator should be unobstructed, and there should be…

[notice color = “red”] This article has not been created. [/notice]

[notice color = “red”] This article has not been created [/notice]

[notice color = “red”] This article has not been created. [/notice]

[notice color = “red”] This article has not been created. [/notice]

[notice color = “red”] This webpage has not been created. [/notice]